Welbilt MERRYCHEF conneX User Manual

5 Service information
Back to contents >
Merrychef conneX
®
service and repair manual 41
5 Service information
5.1 Service procedure
Servicing procedure: overview
1. Disconnect/isolate the appliance from the power supply.
2. Check the appliance is correctly installed as described in the conneX Installation and User manual.
3. Visually check the cleanliness/condition of the power supply/cable, casing, cavity and door of the appliance for signs
of wear, damage, distortion etc. If required, refer to the “Replacing components" section of this manual (section 6).
4. Complete an "Earth/Insulation test" (see section 5.6 of this manual) on the appliance before switching on.
5. Check the display for error messages. If an error is shown, refer to the “Fault Finding” within section 5.3 of this manual.
6. If a firmware update is required, follow the instructions under “Firmware updates” within section 4.5 of this manual
before continuing with the service procedure.
Enter service mode
1. Switch on the oven and wait until the Merrychef screen is displayed.
Select the settings icon.
2. Enter the authorised user password, for example, "MANAGER" on the
keypad.
3. Scroll down and select ‘Service Settings’
4. Enter the service password. For example; ‘SERVICE’ on the keypad.
Select OK (green tick) to display service tabs.
5. Select the relevant tab to access the;
 Event log
 Diagnostic (visual view) screen
 Oven test screen
 Temprature calibration screen
 Demonstration
 Warranty information screen
Select the back arrow at any point to return the previous screen, or to
exit the Service Settings.

Welbilt MERRYCHEF conneX Specifications

General

Brand	Welbilt
Model	MERRYCHEF conneX
Category	Commercial Food Equipment
Language	English