Welbilt MERRYCHEF conneX User Manual

6 Replacing components
Back to contents >
Merrychef conneX
®
service and repair manual 83
6.9 Replacing the UI (User Interface) assembly
Component
The UI is attached to front panel of the oven, electrically connecting to the IO Board,
Speaker and USB receptacle.
Tools required
M5.5 hex socket wrench / nut runner Posidrive PZ1 screwdriver
Discharge tool
Removing the UI assembly
Requirements
Check that the following requirements have been met:
 The appliance has been disconnected from the power supply and protective measures have been taken to
ensure the power cannot be switched on again.
 The appliance is cool.
 Anti-static precautions have been taken.
 The top, left and right panels of the casing of the appliance have been removed.
 The high voltage capacitors are discharged before commencing work.
1. Unfasten the single M5.5 hex head flange bolt fixing the front panel to the cavity
frame. Looking from the front, top right above the IO Board.
2. Lift the front panel upwards and out to detach from the cavity frame.
3. Disconnect the electrical connections; X523 on the IO board, the USB, ethernet and speaker loom connectors.

Welbilt MERRYCHEF conneX Specifications

General

Brand	Welbilt
Model	MERRYCHEF conneX
Category	Commercial Food Equipment
Language	English