Welbilt MERRYCHEF conneX User Manual

5 Service information
Back to contents >
Merrychef conneX
®
service and repair manual 62
1. Ensure the cavity is close to ambient temperature.
2. Enter the Service Settings / Tests and select ‘Recommission Test’ from the appliance tests.
The test will check the appliance in the following order;
 Door switch operation
 Filter switch operation
 Microwave circuits
 Cooling fan operation
 Convection fan operation
 Heater circuit
The test will stop at any point a failure is detected.
After a test has successfully passed, when requested select the green check mark to continue. Selecting the red check mark
as a result of a failure will terminate the recommission test sequence.
Note: If the door is opened during the microwave circuit test, the process will stop and record a failure.
3. When all the tests have been successfully performed the display shows the recommission test has passed. Select the
green check mark to confirm.
4. In the event of a recommission test failure, the detail will be recorded in the Error Log. Rectify any error and repeat
the recommission test.

Welbilt MERRYCHEF conneX Specifications

General

Brand	Welbilt
Model	MERRYCHEF conneX
Category	Commercial Food Equipment
Language	English