Welch MXPC 603 T - Attachment Parts; Accessories; Accompanying Material; Optional Fittings

Description
22 Operating Manual MXPC 303 Z/603 T
4.3 Attachment parts
ATTENTION
Beware of the safety/warning instructions according to chapter 2.4.5 Vacuum.
To ensure safe operation, the attachment parts must always be used (see
chapter 2.3.2 Safe operation).
Side separator inlet
The separator connected upstream on the suction side protects the diaphragm pump.
Condensate and liquid media are collected in the catchpot.
Exhaust vapour condenser
The exhaust vapour condenser filters out the residual vapours and catches them in the
separator at the exhaust.
PNEUMATIC EXHAUST
The device's suction connection must not be closed during operation (see Fig.
4-1/10 and Fig. 4-2/10).
Safety valve
The gas inlet on the emission condenser contains a safety valve. It opens in case of
overpressure, e.g., if it is clogged by deposits. Check the valve seals at regular intervals.
4.4 Accessories
NOTE The scope of delivery is defined by the supply contract.
4.4.1 Accompanying material
Figure
Description
Optional suction port, 2nd application
 Connector for hose
 Compression fitting
See chapter 3.3 General Connections
4.4.2 Optional fittings
Order no.
Designation
Figure
600100
Vacuum controller VCpro 601 table-top device
 Measuring/control device
Working range 1100 – 1 mbar
 Regulation via vacuum control/vent valve
 Operating modes: manual, automatic and
programme
600203
Vacuum pressure gauge with swivel adapter
 Measuring range 1000 – 1 mbar
 360° display
 G1/4" threaded connection
600204
Vacuum pressure gauge (digital) with swivel
adapter
 Measuring range 1000 – 1 mbar
 360° display
 G1/4" threaded connection