Wellav CMP201D - CP2-EAS-00 Basic Settings: IP Output Configuration

CMP201D User Guide
114
Click the Apply button on the right side to make the change take effect.
Name
Range
Name
Range
Command Input Setting
EAS Signal Input
Digital(IP)
Analogue(Dry Contact)
Analogue(Relay)
EAS Program Input
ASI
AV
Trigger Mode
Normally Open
Normally Closed
Encoder Setting
Video Type
H.264, MPEG-2
Audio Type
AC3, Mpeg-1 Layer 2
Mpeg2-AAC, Mpeg4-AAC
Video Bit rate(Kbps)
1500~20000
Audio Bit rate(Kbps)
128， 192， 256，384
Volume
-10~10
When you set the IP output of the EAS module, you should set the same parameters for other
modules that the service(s) will be paved by EAS input (ASI or AV signal). Then the EAS module will
be detected automatically by other modules to complete more configuration. When it is triggered by
external IP or analogue (Dry Contact) signals, the configured services(s) on other modules will be
switched to the AV or ASI services from EAS module.
CP2-EAS-00>Status