CMP201D User Guide
TS setting: Please refer to IP output service configuration.
LCN setting: You need to add NIT streams of all frequencies to the base TS (frequency), which
is for your STB to automatically search and identify all the TS (frequencies) LCN information.
Check or reset Original Network ID and TS ID of each TS (frequency)., Each TS should have
different IDs.
Fill the Original Network ID and TS ID of each TS (frequency) in the field of the base TS
(frequency) and then click Add to create a NIT stream for this TS (frequency).
Click +Descriptor then LCN Descriptor to check all the programs which are contained in this
frequency. Then set programs LCN.
Click +Descriptor and the Cable Descriptor. Then fill in the correct frequency and symbol
rate and choose the correct constellation of the TS (frequency). Then click OK. (This
operation should be set on Modulator module only).
To Next Page
Loading...
