i12 Manual Page 24 - Revision: 6-13-2023
PRE-INSTALLATION
DANGER! ELECTRICAL SHOCK HAZARD.
Only qualified personnel who have read and understand this entire manual should
attempt to install, or service this i12 Ice and Water Dispenser, failure to do so could
result in death or serious injury. DO NOT plug into an electrical supply until specifically
instructed.
WARNING! ALWAYS SANITIZE BEFORE USE.
Sanitize before use to eliminate any potential microbiological contaminates.
Materials Needed:
• Personal Protective Equipment. Rubber or Nitrile Safety Gloves and Protective Eyewear
• Phillips Screwdriver
• Temperature Gauge
• Water Pitcher or Container to collect water from the faucet
• 5-gallon container or drain basin
• Sanitizer - Household Bleach (5.25% Sodium Hypochlorite) or Citric Acid Based Cleaner
• ¼” Plastic Tubing, at least 10 feet in length, and assorted ¼” quick connect fittings
• TDS Meter and Test Strips for measuring chlorine – Optional
1. Unpack the Wellsys i12 Ice and Water Dispenser and check exterior for damage.
CAUTION! FILTER FLUSH REQUIRED.
i12’s Ice and Water Dispensers are supplied with filters. The frequency of filter changes
depends upon your water quality and your water usage. For example, if there is a lot of
sediment and/or particles in your water, then you will have to change your filters more
frequently than a location with little to no sediment. Be sure to replace your filters whenever
you notice a decline in the performance, whether it is a drop of flow rate and/or pressure or
an unusual taste in the water.
2. Flush filters thoroughly per filter manufacturers’ recommendation with fresh water to drain.
More details provided in the Filter Flushing section further down.
NOTE: Filters should not be flushed prior to 24 hours before installation to limit Microbial
Growth inside of filters.
To Next Page
Loading...
