i12 Manual Page 38 - Revision: 6-13-2023
FINAL INSPECTION
After installation and sanitization, verify the following:
1. There are no leaks or loose components.
2. The hot water is over 160˚F.
3. The cold water is below 50˚F.
4. Confirm acceptable product water flow.
5. If the system is not filling, then check the water supply and also make sure the leak stop has
not been tripped. *The leak stop can be reset by removing the cap below the unit and
draining the water out.
6. Ensure the systems exterior is clean and all components are in place.
Other items to check:
1. Once the system has been flushed it should remain plugged in and water should, at a
minimum, be dispensed occasionally. *Avoid storing in your vehicle or warehouse with
residual water in the tank, this will result in a bad taste after installation.
2. Always drain the system before moving it. It is not necessary to drain the hot tank
completely if installing the same day. Leaving water in the hot tank will allow you to turn
the hot tank on immediately after installation of the system but if left overnight may result
in a taste complaint.
3. Never lay the system on its side.
To Next Page
Loading...
