i12 Manual Page 41 - Revision: 6-13-2023
SYSTEM INSPECTION
When changing filters or performing service, the following items should be completed:
1. Visual Inspection
2. Hose & Fitting Inspection
3. Electrical Inspection
4. Pressure and Flow Test
5. Clean the exterior of system and condenser coils on rear of system.
6. Temperature Check (Cold water should be below 50˚F, Hot water should be above 160˚F)
7. TDS Check
8. Hot Tank Switch On
9. Site Cleanup
WARRANTY PROCEDURE
Procedure for I12 warranty evaluation:
Contact WELLSYS technical support and provide the following information:
1. Serial number
2. Failure
3. Full details around failure
4. Water pressure into the system
5. Tap TDS
6. TDS out of the cold and hot tanks
7. Pictures
Depending on the situation, technical support may request more information. Upon approval,
WELLSYS will process warranty credit or replacement part to be fulfilled
To Next Page
Loading...
