EasyManua.ls Logo

Wellsys i12 - Page 5

Wellsys i12
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
i12 Manual Page 5 - Revision: 6-13-2023
floor if needed and secure to the base, if applicable. Never place heavy items on top of unit
and never climb, stand, or hang on unit or storage cabinet to prevent injury and damage.
WARNING! UNIT IS HEAVY. TWO PERSON LIFT REQUIRED. Transport unit empty and always
use material handling equipment or two people with proper lifting technique to reduce injury
risk.
WARNING! STORE AND TRANSPORT UNIT EMPTY. ALWAYS SANITIZE BEFORE USE.
The unit must be completely drained before storing to avoid stagnation and reduce
microbiological contamination (potential bacterial growth). Always sanitize before use to
eliminate any potential microbiological contaminates.
CAUTION! INDOOR USE ONLY. Intended for Household Use. Never expose to direct
sunlight, heat sources, or ambient air temperature above 37°C (100°F) or below 2°C (35°F).
Install indoors and keep unit away from excessive humidity or rain. Never expose to freezing
temperatures. Ensure there is adequate clearance around the unit to allow refrigeration
system condenser to dissipate heat. Warmer environments require more clearance around
the unit. Minimum clearance around all surfaces of the machine is 2-inches. Installs where
the ambient temperature exceeds 27°C (80°F), require a minimum of 4-inches clearance for
proper heat dissipation and efficient operation.
CAUTION! USE A WATER PRESSURE REGULATOR. Wellsys will not be responsible for injury
or damage caused by excessive water pressure. Input or feed pressure must be 40 psi to 80
psi. Be aware of any potential pressure surges caused by building/municipal pumping
stations. Failure to comply will void all warranties. The manufacturer accepts no liability for
damage caused by excessive water pressure.
CAUTION! USE UV STABILIZED SUPPLY LINES. Feed the unit with a potable ambient or
cold-water supply only. Feed water over 37°C (100°F) can damage the treatment
components. Water block devices and external leak detectors are strongly recommended.
Locate the unit as close to the water supply and the electrical connections as possible.
Immediately isolate or close water supply valve and contact service representative if leak is
noticed.
WARNING! SECURE CO2 SUPPLY BOTTLE. When connecting a CO2 tank to the system,
please ensure that the CO2 tank is securely fastened to avoid falling. Failure to secure tank
can result in property damage and/or bodily harm.
WARNING! REFRIGERANT SYSTEM. This system is manufactured with 134A refrigerant.
Repairs to the refrigeration system must be performed by a certified refrigeration technician
only.
CAUTION! DO NOT PLACE HEAVY ITEM OR WATER CONTAINER ON TOP OF UNIT. Water
may leak into the electrical system causing a fire hazard. Heavy items may fall off causing
injury.
Contact Wellsys for assistance or help finding an Authorized Service Representative.

Related product manuals