WELLTECH ATA-172 - Page 32

ATA Web user guide
32 / 114 2015/1/8
Item Decription
of phone1 digit string]. The maximum digit length is 63.
Rings of phone 1 That feature is used for no answer forward only. Default is 3
rings. When there is no answer after configured rings, ATA
forward to pre-configured number automatically. The
configuration ring range is 2 to 8 rings. This mode only supports
Forward Type: No Answer.
Hotline Type of
phone 1
Phone 1 hotline function, default is disable. Enable: ATA will dial
the hotline number immediately when you pick up phone. Note:
You need to configure Hotline number in advance. See the next
row.
Hotline Number
of phone 1
Configure Phone 1 hotline number. You can enter IP address or
number or digit string and the maximum length is 63 digits. For
instance, IP address: 192.168.1.23 or telephone number:
0800024365.
Delay of phone 1 When you pick up the phone before dialing, ATA start to count
time until the first digit was dialed. Default time is 3 seconds.
ATA will use Hotline number to dial if configured time was
expired. The configuration range is 1 to 6 seconds.
DND Type of
phone 1
Configure Phone 1 DND function, default is Disable. When you
set to Enable, ATA will response SIP command 486 message
(Busy status) to calling user once an call incoming. There are 3
options to configure: Disable, Always, Period (DND enable
according pre-defined time period, refer to time setting at next
row).
DND Time of
phone 1
This command is to configure DND time period at phone 1.
Default is From 0:0(start time) To 0:0(end of time). The time
format is 24 hours system (hh/mm, Hours/Minutes). Each field
has 2 digits number only.
Alarm Type of
phone 1
Default is Disable. Configure Phone 1 alarm function. When you
set to enable, phone 1 will Ring according to pre-configured (see
next row how to configure alarm time) alarm time. The alarm
Ring last for 1 minute. To cancel alarm setting, simply pickup
handset and hand up. The default ring time is 1 minute.
Alarm Time for
phone 1
Default is 0:0(Hour/Minute). The time format is 24 hours
system(hh/mm). Each field allows to enter 2 digits number only.
Submit Save the configuration.
6.3.3 Operational Description
Example 1: Forward Feature
 All (Unconditional Forward)
Step 1: In [Call Service Setting] web page, Setup [ Forward Type: All, Forward Number:
812345678] (See Figure 1).
(Figure 1)