WELLTECH ATA-172 - Page 86

ATA Web user guide
86 / 114 2015/1/8
Step 3: On [Auto Configuration Setting], Set up [Type: TFTP, 2 Steps Configuration:
Enable, TFTP Server: 192.168.50.99] (See Figure 6).
(Figure 6)
Step 4: In [Service Domain Setting] web page, Check [Realm: 1] Settings, Use
[MACID.dat] file to load configuration (See Figure 7).
(Figure 7)
Example 4： Server Auto Discover
 Broadcasting
Step 1: In [Auto Provision Setting] web page, Set up [Provision Active: TFTP, Server
Auto Discover: Broadcasting] (See Figure 8).
(Figure 8)
Step 2: In [Auto Provision Setting] web page, Check [Provision Active: TFTP, TFTP Server:
192.168.55.91, TFTP File Path: config/] (See Figure 9).
Note：If starts TFTP Server at the same time, this field parameter can’t see data. Because
of this data upload provision function by TFTP Server.