Westerbeke 4.5 BCG - Shore Power Transfer Switch

SHORE POWER TRANSFER SWITCH
120 VOLT/60 HERTZ TWO WIRE CONFIGURATION
Switching Shore Power to Generator Power
If the installer connects shore power to the vessel's AC
circuit, this must be done by means of the Shore Power
Thansfer Switch .. Set the transfer switch shown in the
diagrams. to the OFF position. This switch prevents
simultaneous connection of shore power to generator output.
A CAUTION: Damage ta the generator can result H
atUlty share power and generator output am connectsd
at the same time. Tiiis type al g1111erator damage Is not
conretl undsr the warranty; It Is the Installer's rssponsl·
bHity to make sum all AC connections are corrsct.
g
. NOTE1D19.- s'-S CIClllllectlaal tor• -
wlq, 12Q•Yolt .,....,, - - ... -.
- tllNe-1re, 120-V01t - a,stem.
- ID
!i: -
!
I
:
z:
. A CAUTION: HeartT motor leads.should be shut off
befon1 switching shors panr ts gsneratar power or
vics-veTSa because voltage surges Induced by switt:hlng
with hsary AC loads on th11 vessel being opllfllled may
causs damage to the excltlll' aln:ult components In tbs
generator.
NOTE: Die9ftllll 1111oW COllMctioa tor a --
/ N G1 G2 \ wire.1ZO.VoltSJStem. For•three-wiN •-
t ... - dotted 11- for the other bot lee·
I
I
I. ,,,-,
'----+<D !&..l..
r--:--J~ ~
I , __ ....
I
I
I
I
I
I
I
Engine_s &_Generators
39