Western Digital Ultrastar Data102 - Revision History

User Guide Revision History
Revision History
Date Revision Comment
November 2017 Revision 1.0 Initial Release
November 2017 Revision 1.1
• The crossbar on the CMA was changed. See CMA Description
(page 52).
• Removed Lowline power specs from Power Requirements
(page 17).
• Changed required rack depth, see Required Rack Depth (page
5).
• Changed typical power consumption, see Typical Power
Consumption (page 4).
• Updated LED Flash Patterns, see LEDs (page 8).
December 2017 Revision 1.2
• Added active cable support
• Added firmware upgrade section. See Firmware Upgrade
(page 181).
• Updated the Non-Op altitude specification. See Non-
Operational Altitude (page 4).
January 2018 Revision 1.21 Updated the product name
January 2018 Revision 1.3
• Updated information on the 2.5" drive carrier option. See 2.5"
Drive Carrier Description (page 59).
• Added torque requirements for all screws used in the
enclosure.
• Updated the IOM replacement section to account for the
possibility of a firmware mismatch. See IOM Replacement
(page 65).
• Updated the drive assembly installation instructions to clarify
the orientation of the drive assemblies. Drive Assembly
Replacement (page 75).
April 2018 Revision 1.4
• Updated Compatible Drives List. See List of Compatible Drives
(page 20).
• Updated the Rack Requirements. See Ultrastar Data102 Rack
Requirements (page 14).
• Updated the Firmware Upgrades. See: Firmware Upgrade
(page 181)
May 2018 Revision 1.5 Added the Part Replacement Service Window. See: Part
Replacement Service Window (page 65)
June 2018 Revision 1.6
• Updated Compatible Drives List. See List of Compatible Drives
(page 20)
v