3-8
Timer Delay
To set the Timer for a 1- to 24-hour delay
until the air conditioner turns off (the air
conditioner must be On):
1.
Press TIMER OFF. Timer “OFF 00:00”
indicator light will flash.
NOTE: On the control panel, press and hold
FAN for 3 seconds to change vertical airflow
direction. Press and hold FAN for 3 seconds
again to stop airflow louver at desired airflow
direction.
NORMAL SOUNDS
When your air conditioner is operating normally,
you may hear sounds such as:
D
roplets of water hitting the condenser, caus-
ing a pinging or clicking sound. The water
droplets help cool the condenser.
Air movement from the fan.
Clicks from the thermostat cycle.
V
ibrations or noise due to poor wall or window
construction.
A
high-pitched hum or pulsating noise caused
by the modern high-efficiency compressor
cycling on and off.
•
•
•
•
•
CHANGING AIR DIRECTION
Press SWING (on remote control only) once to
change vertical airflow direction. Press again
to stop airflow louver at desired airflow direc-
tion.
2.
Press the plus or minus button to change
the delay time (1 to 24 hours).
3.
Press TIMER OFF again. Timer “OFF
00:00” indicator light will remain on.
T
o set the Timer to turn on the air condi-
tioner
, keeping previous settings:
1. Turn off air conditioner.
2. Press TIMER ON. Timer “ON 12:00” indi-
cator light will fl
ash.
3. Press the plus or minus button to change
the delay time (1 to 24 hours).
4.
Press TIMER ON again. Timer “ON 12:00”
indicator light will remain on.
T
o set the Timer to turn on the air condi-
tioner
, changing the previous settings:
1. Turn off air conditioner.
2. Adjust Mode to ComfortMode
™
control,
Cooling, Dry, Fan or RapidCool
™
.
3. For Cooling:
Adjust fan speed to High, Low or Auto.
Adjust temperature between 64°F
(18°C) and 90°F (32°C).
4. For Fan mode, adjust fan speed to High
or Low.
5. For ComfortMode
™
control and Dry modes,
adjust temperature up or down by 4°F
(2.2°C).
NOTE: In Fan mode, temperature cannot
be set.
6.
Press TIMER ON. Timer “ON 12:00” indi-
cator light will flash.
•
•
7.
Press the plus or minus button to change
delay time (1 to 24 hours).
8.
Press TIMER ON again. Timer “ON 12:00”
indicator light will remain on.
T
o clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER OFF for 3 seconds.
Timer indicator light will turn off.
To see or change the remaining time (in
hours):
1.
Press TIMER ON or TIMER OFF once
after it has been programmed.
2.
While the display is showing the remain-
ing time, you can press the plus or minus
button to increase or decrease the time.
NOTE: Timer On and Timer Off can be set at
the same time.
To Next Page
Loading...
