WhisperKool Platinum Split - Ventilation and Ambient Temperature

www.whisperkool.com | Page 11
PREPARING THE EVAPORATOR UNIT (FAN COIL UNIT)
Install the supplied strain relief to secure probe wire. Using
pliers, clamp the strain relief around the probe wire and insert
the strain relief into the hole the probe wire is coming from.
(Note: Strain Relief will snap in to place when fully inserted.
Perform a pull test to ensure the strain relief connection is
tight.)
Circular Connector
Bottle Probe Connector
Connecting the bottle probe to the circular connector: Insert
the bottle probe connector into the circular connector and
twist the bottle probe connector clock wise to lock in place.
Insert bottle probe connector through the opening on the rear
panel.
11
13
12