widos 5500 - Page 30

Kunststoffschweißtechnik
Foundation: 2207, 2208 DIN 16932 German association for welding
Use for: 5100 OD 200 - 450
5500 OD 200 - 500
The data in the colored, labeled arrays are interpolated, no garantee, based on DVS 2207 part 11
1 bar on manometer: 141 N
time to
change- reach full
over welding cool-down time
0,10 (PP) time pressure
pressure in
Tdesired
temperature
time
pipe pipe SDR bead-up circular heat-up max. time welding cool-
diameter wall pressure bead time change- to reach pressure down
OD (s) [bar] min. [s] over welding [bar] time
[mm] [mm] [mm] time pressure [min]
[s] [s]

200 4,9 41 3 0,5 141 5 6 3 7
200 6,2 33 3 0,5 162 6 7 3 10
200 7,7 26 4 1,0 185 6 8 4 13
200 11,4 17,6 5 1,0 237 7 11 5 19
200 18,2 11 8 1,0 320 9 16 8 29
200 27,4 7,4 11 2,0 411 11 23 11 42
200 33,2 6 13 2,0 456 13 29 13 50
225 5,5 41 3 0,5 151 5 6 3 8
225 6,9 33 4 0,5 173 6 7 4 12
225 8,6 26 5 1,0 197 6 8 5 15
225 12,8 17,6 7 1,0 255 7 12 7 21
225 20,5 11 10 1,5 345 9 18 10 32
225 30,8 7,4 14 2,0 437 12 26 14 47
225 37,4 6 16 2,5 487 14 32 16 55
250 6,2 41 4 0,5 162 6 7 4 10
250 7,7 33 5 1,0 185 6 8 5 13
250 9,6 26 6 1,0 211 7 9 6 16
250 14,2 17,6 8 1,0 272 8 13 8 23
250 22,7 11 12 1,5 367 10 20 12 35
250 34,2 7,4 17 2,0 463 13 29 17 51
280 6,9 41 5 0,5 173 6 7 5 12
280 8,6 33 6 1,0 197 6 8 6 15
280 10,7 26 7 1,0 227 7 10 7 18
280 15,9 17,6 10 1,0 292 8 14 10 26
280 25,4 11 15 1,5 394 11 22 15 39
280 38,3 7,4 21 2,5 493 14 33 21 57
in welding area
The smaller the pipe wall the higher the temperature.
P (N/mm²)
bead-up heat-up
Table for PP
Additional to the given bead-up force and to the welding force the moving force of the support must be added !
The standard value for heating element temperature is 210° C +/- 10° C.
welding area
17.02.2014 Working instructions WIDOS 5500 Page 27 / 1 of 48