Table limit switch actuated
Remove the wash rack from the
outlet table.
Remove the block (e.g. jammed
dishes).
Water drain is blocked or
drain pump is defective
Contact an authorised service tech-
nician.
Strainer in the tank is
clogged. Machine goes into
standby.
Remove, clean and re-insert the
strainer.
Press the or button to restart
the rack conveyor.
Poor cleaning result
INFO The water quality affects the washing and drying performance. We therefore
recommend from a total hardness of more than 3° dH (0.53 mmol/l) that the ma-
chine is supplied with softened water.
The dishes do not get clean
No or low detergent dosing
Contact an authorised
service technician to set
the dosing amount.
Check dosing hose (for
kinks, breakage, ...)
Replace the storage con-
tainer if empty.
Dishes incorrectly sorted
Do not stack dishes one
over the other.
Jets of the wash arms
blocked
Remove the wash arms
and clean the jets.
Check temperatures ( 10)
There is formation of layers
on the dishes
In case of limescale depos-
its:
The water is too hard
Check external water trea-
tment.
In case of starch residues:
Excessively high tempera-
tures during manual pre-
cleaning (hand shower)
The temperature of the
manual pre-wash should be
a maximum of 30 °C
To Next Page
Loading...
