Winterhalter C50 - Machine and Table Installation; Installation Site and Leveling Requirements

27
Programming settings
 Access the PIN Menu.
3x
Enter PIN 1575. To do this, select the individual
figures with the and buttons and con-
firm each figure with the button.
 Select settings for the detergent and rinse aid dosing device in the table on page 26.
The setting for the detergent dosing device is displayed (number
flashes).
Confirm with the button or select the value 0 with the button
and confirm with the button.
The setting is saved.
The setting for the rinse aid dosing device is displayed (number
flashes).
Confirm with the button or select the value 0 with the button
and confirm with the button.
The setting is saved.
Press and hold the button to exit the menu.
23 Installing the machine and tables
Notes for the service technician or dealer authorised by Winterhalter:
 Observe the connection diagram for detailed information.
 The installation site must be frost-resistant so that the water systems do not freeze.
Installing the machine
INFO No gap is required between the wall and rear of machine.
 Install the machine horizontally with the help of spirit level.
Attaching tables
 Refer to the table connection drawing (on request).
ext.
ext.
1
ext.
1