Winterhalter C50 - Malfunctions and Troubleshooting; Understanding Malfunction Categories; Troubleshooting Common Malfunctions

18
17 Malfunctions
Malfunctions are shown in the display in the form of pictograms. With some malfunctions
washing is still possible, however, the wash result will be impaired. Therefore resolve any
malfunction as soon as possible.
Category 1 malfunction
 Resolve the malfunction.
 Display turns green.
Washing is then possible without restriction.
Category 2 malfunction
 Press the button.
If the malfunction is still present, the display lights up yellow.
Certain components are switched off to protect against further
damage. Washing is possible to a limited extent after pressing
the button.
 Read the error code and contact an authorised service
technician for the repair.
Category 3 malfunction
 Read the error code and contact an authorised service
technician for the repair.
Washing is not possible without repair.
Pictogram
Cause/meaning
Remedy
Lack of water or uncon-
trolled water supply
Open the on-site water supply.
Have the dirt trap cleaned by a ser-
vice technician or have a new dirt
trap installed.
Contact an authorised service tech-
nician.
Door was opened at an
inadmissible time (e.g. dur-
ing washing)
Close the door.
Detergent container is emp-
ty
1
Change the detergent container.
Rinse aid container is emp-
ty
1
Change the rinse aid container.
1
is only displayed, when a suction tube with level control is connected to the machine