WITTUR MIDI - 11.4.3 F1: Door Movement; 11.4.4 F4: Next (Door Movement)

Door Drive
MIDI / SUPRA
Operating instructions
Blatt/ sheet D823MGB.022
Datum/
date 01.03.2004
Stand/
version B-18.12.2008
Geprüft/
approved WAT/MZE
EXCELLENCE IN COMPONENTS
Änderungen vorbehalten! Subject to change without notice!
11.4.3 ‘F1’: Door Movement
This menu allows you to watch/modify values
described in the following chapters by pressing the
corresponding function key.
See chapter 11.4.2.1 how to enter values.
All these variables are stored in the EEPROM.
Speed values for speed setting 1-3 are calculated
from values of speed setting 4 by multiplying with
fix constants (see chapter 12).
11.4.3.1 ‘F1 Open speed’ - Open speed.
Top speed for open movement; speed setting 4.
11.4.3.2 ‘F2 Close speed’ - Close speed
Top speed for close movement; speed setting 4.
11.4.3.3 ‘F3 Nudging speed’ - Close speed for
nudging
Top speed for close movement with nudging com-
mand; speed setting 4.
11.4.4 ‘F4’: Next (Door Movement)
This menu allows you to watch/modify values
described in the following chapters by pressing the
corresponding function key.
See chapter 11.4.2.1 how to enter values.
This value is stored in the EEPROM.
11.4.4.1 ‘Brake Parameter’
Because of the adjustment of this parameter the
delay and creep to the open / close end is influen-
ced. The possible adjustment is ‘0’..’9’, but the ear-
liest brake is reached with parameter ‘0’ and the
latest delay is reached with parameter ‘9’.
11.4.4.2 ‘Position Out’ Relay output
By entering this parameter the Position relay can
be adjusted to switch at any door position.
Standard adjustment is 0 (deactivated).
11.4.4.2 ‘Acceleration’
By adjusting this parameter the acceleration of
door can be changed. The adjustment is done in
m/sec².
F1 Open Speed
F2 Close Speed
F3 Nudging Speed
F4 Next F8 Back
F1 Brake Parameter
F2 Position Out
F3 Acceleration
F4 F8 Back