18. Siren Setting
By default the alarm unit will beep to indicate when the alarm is armed or disarmed. If a louder
indication is needed the siren can also be activated to indicate this.
While in settings mode, use the keypad to enter [75] select if the siren should sounds or not [0/1]
and then press [#] to confirm. The main unit will emit a long beep and a voice prompt “setting
completed”.
Operating method: [75][A][#]
A indicates: [0] Siren off; [1] Siren on; System default: [0] Siren off
For example: set siren on when arm/ disarm
Operating method: [75][1][#]
LCD display:
19. Siren Setting in “Emergency Help/Panic” mode
When the panic button is pressed the siren can be set to sound or not.
While in settings mode, use the keypad to enter [76], and then [1/0], finally press [#]
to confirm. The main unit will make a long beep and a voice prompt “setting completed”.
Operating method: [76][A][#]
A indicates: [0]: siren off in “Emergency Help” mode
[1]: siren on in “Emergency Help” mode
System default: [0] siren off
20. Alarming Record Checking
While in settings mode, input [*0#], the main unit will make a long beep and enters into alarm
record checking mode. After displaying the alarm and defence zone number indicator, the LCD
screen will display the exact alarming time of this defence zone. Press 2 to check the previous
alarming record; press 8 to go to next record and press [*#] to exit checking.
Example: the 51st defence zone; the 7th alarming; alarming time:
12:10, August 1st, 2008.
LCD display for one second
and then display the alarming time:
Page 16 Wolf Secure http://www.wolfsecure-gsmalarms.co.za
To Next Page
Loading...