Wolf Secure Wolf Guard - Function Settings: Advanced System Features; Controlling All System Voice Prompts; Wireless Transmitter Operations; Setting Alarm Delay Time

A indicates: [1]: activate voice prompt for arm/ disarm (factory default)
[0]: deactivate voice prompt for arm/ disarm
Voice Prompt for All Settings
This setting is used to enable/disable all voice prompts.
In setting status, first input [84], then [0/1] and finally press [#] to confirm; voice prompts: setting
completed, please enter instruction.
Operating method:[84][A][#]
A indicates: [1]: activate voice prompt for arm/ disarm (factory default)
[0]: deactivate voice prompt for arm/ disarm
Note: after you deactivate this function, all the voice including arm/ disarm voice will not work.
25. Wireless transmitter operations
The alarm system is able to send wireless signals to different devices to activate/deactivate them. A
good example will be to control a wireless outdoor siren and strobe unit.
Activate/deactivate the transmitter
Operating method: [41] [0/1] [#]
[0]: turn off the function of wireless transmission
[1]: turn on the function of wireless transmission
For example: turn the wireless transmission function on:
Operating method: [41] [1] [#]
26. Time Setting of Alarm Delay (Default: 40 sec)
In setup status, use keypad to input [45], then input delay time [01] ~ [99], and then input [#] to
confirm. You will hear a long beep and a voice prompt “setting completed”.
Operating method: [45] [AA] [#]
AA indicates: the code number 01~99
For example: set the wireless coding number as 65
Operating method: [45] [65] [#]
LCD display:
Note: Alarm delay is effective only for zones that are set as a delay zone (see defence zone
programming)
27. Voice Prompt for All Settings
For all above settings, you could hear the voice prompt such as “setting completed, please enter
instruction”, “delete completed”. You can deactivate the voice if you do not need them.
In setting status, first input [84], then [0/1] and finally press [#] to
confirm. The main unit will make a long beep and voice prompts:
setting completed, please enter instruction.
Operating method: [84] [0/1] [#]
[1]: activate voice prompt for all operations (factory default)
[0]: deactivate voice prompt
For example: Set voice prompt OFF
Operating method: [84] [0] [#]
Page 18 Wolf Secure http://www.wolfsecure-gsmalarms.co.za