Wolf Secure Wolf Guard - Function Settings: Security and Operation Overview; Tamper Alarm and IMEI Code Check; Operation Instructions: System Status and Controls; System Statuses and Remote Controller Usage

To Next Page

To Previous Page

Note: after you deactivate this function, all the voice including arm/disarm voice will not work.

28.Tamper Alarm Setting

There is a tamper alarm button at the back side of the panel. If you install the panel with the bracket

(included in the standard pack), this button will be pressed down. When someone is trying to

disassemble the panel, the button will be loosen once the bracket is taken off and the system will

make alarm at the same time. In setting status, first input [87], then press [0/1] and finally press [#] to

confirm. The main unit will make a long beep and voice prompts: setting completed.

Operating method: 【87 】【0/1 】【#】

[0]: Tamper alarm OFF (factory default)

[1]: Tamper alarm ON

For example: Set Tamper alarm ON

Operating method: 【87 】【1 】【#】

Note: The alarm SMS is “zone 99 emergency alarm"”.

29.IMEI Checking

In setting status, first input [88] and then press [#] to confirm. The 15-digit IMEI code will be

displayed separately in 4 pages (2 seconds per page) on the screen.

Operation Instructions

1. System statuses.

1) Arm: defence zone 1~99 will alarm when detectors are triggered

2) Home Arm: in home arm status, the defence zone which is set as [Home Arm] will alarm when

detectors are triggered.

3) Disarm: defence zone 1~99 will not alarm when detector are triggered (except 24 hours defence

zones)

4) System setup status: In this status, all defence zones will not alarm when detectors are triggered.

2. Remote Controller Operation

Users can use the remote controller to arm (Out Arm, Home Arm), Emergency Alarm/panic button

and to disarm the alarm.

1) Out Arm: Press the button

2) Disarm: Press the button

3) Home Arm: Press the button

4) Emergency Alarm:Press the button,system will alarm at once.

3. Keypad operation

Activate Out Arm with the alarm keypad

Out arm is used when there is nobody inside the protected property and all sensors will be active

Press [Out Home ] button on keypad, system will make one beep per second for a total of 100

Page 19 Wolf Secure http://www.wolfsecure-gsmalarms.co.za