Wolf CGB-2-24 - Page 20

20 3064810_201804
10.Installationdimensions
Bild: Bohrlöcher für Einhängewinkel
Seite 12
Bild: Einhängeverstrebung an der Gastherme
1. Mark the Ø12 holes to be drilled for the suspension bracket,
taking into account the minimum clearances.
2.Inserttherawlplugsandtthesuspensionbracketusing
the screws supplied.
3. Hook the boiler onto the suspension bracket using the
mounting stay.
Mounting stay
Fig: Mounting stay on the combi boiler
Fig: Drill holes for suspension bracket
Securingtheappliancewiththesuspension
bracket
Wheninstallingtheappliance,ensurethatthexings
havesufcientload-bearingcapacity.Alsotakeinto
account the condition of the wall,as an escape of
gas or water might result in a risk of explosion and
ooding.
Bild: Bohrlöcher für Einhängewinkel
Seite 12
Bild: Einhängeverstrebung an der Gastherme
min. 552 mm
Ceiling