Wolf FGB-35 - ISM7 e Module Options

3064458_201811
27
The ISM7e interface module enables remote access to components of the FGB/FGB-K gas condensing boiler via networks and
the internet.
The connection is made via eBus.
The ISM7e interface module enables the user to display current states, readings and parameters of the gas condensing boiler
and to input various settings. The ISM7e is designed for installation outside a gas condensing boiler and is supplied with a
casing that is also suitable for wall mounting. The ISM7e interface module can be integrated into an existing network either with
a network cable (LAN) or wirelessly (WLAN).
For secure communication over the internet, the ISM7e interface module is linked to the existing DSL router, through which a
secure connection to the Wolf portal server is established.
The system is operated over the internet either by means of the Wolf portal user interface operated via internet browser or with
the "Smartset" smartphone app, which can be downloaded and installed from the appropriate app store.
An internet connection is not required if access to the gas condensing boiler is to be limited to the local home network.
Operation from within the home network occurs either via the "Wolf Smartset" smartphone app or via the "Smartset" Windows
PC application (available to download from the Wolf website: www.wolf-heiztechnik.com).
Connection extension for ISM7e digital Wolf control accessories
Module description
The following operating options are available
1. ISM7e module with FGB/FGB-K without programming unit in eBus system
Wolf portal
server
Local (home)
network
DSL router
(LAN / WLAN)
LAN / WLAN
Wolf boiler with
ISM7e interface
module
FGB/FGB-K operating
options without
programming unit
Description Authorisation
Operating mode Possible system status – winter, summer, standby (off) Change
Set ow temperature
Permanent set ow temperature with non-weather-compensated control unit (H54=0) Change
Set value correction (±4) Weather-compensated control unit (H54 > 0, heating curve active) Change
Set DHW temperature Only if DHW heating is available
(cylinder, wall mounted combi boiler, H51:1,2,3).
Change
Control parameters (H...) For safety reasons some of the control parameters cannot be changed here Change
(limited)
Message history Message history can be displayed via PC application or smartphone app Display
Fault message Fault messages can be sent by email to one or more fault message addresses Send
All functions such as operating modes, expert parameters, frost protection, etc. occur in the FGB/FGB-K.
The ISM7e interface module is only for remote adjustment and to display active faults and the message history.
2. ISM7e module with FGB/FGB-K with BM-2 programming unit in eBus system
FGB/FGB-K operating
options with BM-2
Description Authorisation
Additionally full functionality of BM-2 (see BM-2 installation instructions); signicant features are:
Room inuence For a description, see BM-2 installation instructions Change
Summer/winter changeover For a description, see BM-2 installation instructions Change
ECO / ABS For a description, see BM-2 installation instructions Change
1x DHW Single DHW heating (see BM-2 installation instructions) Change
14. Electrical connection