Operation
Operation
1
1-4 doc021820 Operation
1.3 Operation
Set up the sawmill as instructed in your sawmill operator’s manual.
Install the charged battery.
Transmitter electronic system constantly controls battery voltage. When it falls below the appropriate
value, the LED indicator light will turn red or an acoustic signal will be heard after which the system
will automatically turn off. In this case, perform the following steps:
Set the saw head in safe position.
Turn the key to the “0” position. The transmitter will be turned off. Remove the key.
NOTE: When the battery is fully charged, the panel should work for
approximately 20 hours at 20
o
C.
Charging the battery.
To remove the battery, move it forward and lift.
Place the battery in the charger provided by the manufacturer. Use original charger only.
Be sure the charger is connected to the appropriate power supply (220-230V socket or car plug
etc.)
The battery requires about 3-6 hours to be fully charged. Control light CHARGE is on during
charging. When battery is fully charged control light READY illuminates. To charge the battery
fast, push the FAST CHARGE button.
CAUTION! Charger automatically stops charging when the battery is
fully charged. One of the batteries should always be in the charger, as
a spare fully charged battery.
CAUTION! If batteries are not in use for a long time, they should be
charged every 6 months.
To Next Page
Loading...
Need help?
General
