Wood-mizer MP200 E6S - Page 8

INTRODUCTION
Machine description
1
1-4 doc021023 INTRODUCTION
 Wrench 10 mm
 Box wrench 13 mm
 Flat wrench 30 mm (supplied) (for cutter)
 Adjustable wrench 8” or 10” (cutter)
 Slide caliper
 Measuring tape or ruler
 Paraffin oil for grindstone
FOLLOWING SPACER RINGS ARE SUPPLIED:
 3 x 40 mm height (per cutter)
 2 x 20 mm height (per cutter)
 2 x 10 mm height (per cutter)
 1 x 5 mm height (per cutter)
 1 x 2 mm height (per cutter)
 1 x 1 mm height (per cutter)
 1 x 0.5 mm height (per cutter)
 1 x 0.3 mm height (per cutter)
 1 x 0.2 mm height (per cutter)
 1 x 0.1 mm height (per cutter)
These spacer rings are necessary to set the required height.