Wood-mizer MP280 - Page 98

PLANER/MOULDER SPECIFICATIONS
Specifications of the planer/moulder
7
7-6 doc050624 PLANER/MOULDER SPECIFICATIONS
See table 7-5. The noise level generated by Wood-Mizer planer/moulder is given in the table
below
1 2 3
IMPORTANT! The total value of hand-arm vibration the operator may
be exposed to does not exceed 2.5 m/s
2
. The highest root mean
square value of weighted acceleration to which the whole operator’s
body is subjected does not exceed 0.5 m/s
2.
See table 7-6. See the table below for planing/moulding material specifications
Noise Level
Planer/Moulder MP280
Equipped with electric motor
L
WA (idling)
= 87,3 dB (A)
L
WA (under load)
= 100,7 dB (A)
TABLE 7-5
1. The noise level measurement was taken in accordance with PN-EN ISO 3744:2011 Standard . Value for
associated uncertainty K=2.
2. The measured values refer to emission levels, not necessarily to noise levels in the workplace. Although
there is a relation between emission levels and exposure levels, it is not possible to determine with certainty if
preventives are needed or are not needed. Factors that influence the actual level of exposure of the workforce
include the characteristics of the work room and the other sources of noise etc. i.e. the number of machines
and other adjacent processes. Also, the permissible exposure level value may vary depending on country. This
information enables the machine’s user to better identify hazards and a risk.
3. The total value of hand-arm vibration the operator may be exposed to does not exceed 2.5 m/s
2
. The high-
est root mean square value of weighted acceleration to which the whole operator’s body is subjected does not
exceed 0.5 m/s
2
.
One-sided planing Double-sided planing Four-sided planing
Minimum Cant Height 10mm 10 mm 10 mm
Maximum Cant Height 230 mm 230 mm 100mm
Maximum Cant Width 410 mm 300 mm 250 mm
TABLE 7-6
!