To Next PageTo Next Page
Need help?Do you have a question about the Worcester OIL HEATSLAVE 12/14 and is the answer not in the manual?
Covers requirements for installer competence, adherence to British Standards, and manufacturer's notes.
Explains the Benchmark initiative, RS balanced flue benefits, and fuel type requirements for the appliance.
Details the different operating modes: Central Heating, Domestic Hot Water, and combined modes.
Provides detailed technical specifications, including model output, burner data, and performance parameters.
Outlines the necessary clearances and positioning requirements for safe installation and servicing of the appliance.
Step-by-step guide for safely removing the appliance's cabinet panels for access.
Specifies the minimum air inlet areas required for open flue and room sealed appliance installations.
Details requirements for conventional flue installation, terminal siting, and flue system guidance.
Covers oil tank installation, pipework requirements, and system configurations like single vs. double pipe.
Lists essential components for the oil supply pipework, including valves and filters.
Discusses how the boiler integrates with central heating and hot water systems, including diverter valve logic.
Details specific pipework requirements for sealed and open vent primary systems.
Covers compliance with BS standards, expansion vessel calculations, and system filling procedures for sealed systems.
Provides guidance on setting up an open vent system, including pipework and air venting.
Details mains water inlet requirements, pressure limits, flow rate control, and temperature considerations.
Addresses requirements for hard water areas and back-flow prevention devices.
Covers electrical wiring compliance, isolation methods, and mains supply specifications.
Explains how to connect programmers and thermostats to the appliance's control system, referencing diagrams.
Details the installation of external programmers and thermostats, including safety checks.
Outlines essential safety checks for the electrical system after installation.
Illustrates the boiler's operational logic for various modes: CH/DHW, DHW only, and CH only.
Covers unpacking, initial heating system flush, and domestic water connections before fitting.
Details the steps for commissioning the appliance, including system preparation, burner adjustment, and final checks.
Guides on handing over the appliance to the user and explaining its operation and maintenance.
Outlines the regular maintenance tasks for cleaning and inspecting the boiler and its components.
Details how to access and replace key components such as the burner, pump, and diverter valve.
General