Page 4
1.0 Safety Information.
INCORRECT INSTALLATION, OPERATION, OR MAINTENANCE OF EQUIPMENT
MAY CAUSE SEVERE PERSONAL INJURY OR DEATH AND/OR EQUIPMENT
DAMAGE AND MAY INVALIDATE THE WARRANTY.
THIS INFORMATION MUST BE READ FULLY BEFORE BEGINNING
INSTALLATION, OPERATION, OR MAINTENANCE AND MUST BE KEPT WITH
THE PUMP. SUITABLY TRAINED OR QUALIFIED PERSONS MUST UNDERTAKE
ALL INSTALLATION AND MAINTENANCE ONLY.
DANGER
DO NOT OPERATE PUMP IF:
- The front cover is not installed correctly.
- Any guards are missing or incorrectly installed.
- The suction or discharge piping is not connected.
DO NOT place fingers, etc. into the pumping chamber or its connection ports or into
any part of the gearbox if there is ANY possibility of the pump shafts being rotated.
Severe injury will occur.
DO NOT exceed the pumps rated pressure, speed, and temperature, or change the
system/duty parameters from those for which the pump was originally supplied,
without confirming its suitability for the new duty. Running of the pump outside of its
operation envelope can cause mechanical contact, excessive heat and can represent
a serious risk to health and safety.
Installation and operation of the pump must always comply with health and safety
regulations.
A device must be incorporated into the pump, system, or drive to prevent the pump
exceeding its stated duty pressure. It must be suitable for both directions of pump
rotation where applicable. Do not allow pump to operate with a closed/blocked
discharge unless a pressure relief device is incorporated. If an integral relief valve is
incorporated into the pump, do not allow re-circulation through the relief valve for
extended periods.
To Next Page
Loading...