Page 8
2.0 Introduction.
2.1 General.
Revolution circumferential piston and rotary lobe pumps are manufactured by Wright
Flow Technologies a unit of the IDEX Corporation.
2.2 Wright Flow Technologies Distributors.
Wright Flow Technologies distributes its products internationally via a network
of authorised distributors. Throughout this manual where reference is made to
Wright Flow Technologies, service and assistance will also be provided by any
Wright Flow Technologies authorised distributor for Revolution.
2.3 Receipts and Storage.
Upon receipt of the pump, immediately examine it for any signs of visible
damage. If any damage is noted, contact Wright Flow Technologies or your
Wright Flow Technologies distributor and clearly mark upon the carriers’
paperwork that the goods have been received in a damaged condition, with a
brief description of damage.
If the pump is not required for immediate installation then it should be stored in
a clean, dry environment. It is recommended that storage temperature should
be between –10 and 40C (14°F and 105°F).
2.4 Cleaning.
The Revolution pump series is suitable for both manual cleaning and CIP
(Cleaning In Place), refer to section 3.4.2.
It is recommended that the exterior of the pump be cleaned periodically with a non-
aggressive, non-abrasive cleaning solution.
2.5 Pump Model Designation.
The designations of pump models in the Revolution range are as follows:
Fig 1 Designations
To Next Page
Loading...