Wurtec S3 Communicator Master Station - Quick Set-Up (Onboard Keypad) - Continued; Resetting to Factory Defaults

24 pages

To Next Page

To Previous Page

Buy Online! Wurtec.com 11

Quick Set-Up (from onboard keypad) cont.

Resetting to Factory Defaults

STEP 1 To reset everything to factory defaults press the

VOL UP

and

VOL DN

keys at the exact

same time.

STEP 2 The phone will say “Factory defaults, press

to reset to default,

to cancel,

VOL UP

then

to disconnect.” To reset to default press the

button on the

keypad. The phone will then say “Reset” and then shut off. At this point anything

that has been programmed in the phone is erased and reset to factory defaults.

Factory Defaults are as follows:

Voice Announcements - On

Call Cancellation - Off

Immediate Two-Way Conversation - Off

Maintenance Announcements - Off

Ring Count - 1 Ring

Volume - Mid Level (4)

Emergency Phone Numbers - None

Site ID Message - None

Announcements - None

Talk Time - 180 seconds

Touch Tone ID - None