Wurtec S3 Communicator Master Station - Programming (Locally or Remotely) - Advanced Options; User Preferences - Maintenance Announcements On;Off; Talk Time

14 Buy Online! Wurtec.com
Programming (Locally or Remotely) | Advanced Options
User Preferences - Maintenance Announcements On/Off
When Maintenance Announcements are ON voice prompts are enabled for: external power
failure, battery failure, and telephone line failure. If there are any failures you’ll hear them
announced in the car: “External power failure” or “Battery failure” or “Telephone line failure.”
The message is played every 5 minutes for external power and battery failure until fi xed. The
message for telephone line failure will play for the fi rst time after 30 minutes and then every 5
minutes thereafter until it is fi xed.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
1
for user preferences.
STEP 4 Press
4
for maintenance announcements.
STEP 5 Once in the maintenance announcements menu, you can press
1
to turn
on maintenance announcements. Press
2
to review whether maintenance
announcements are on or off (maintenance announcements are off by default).
Press
#
VOL DN
to return to the previous menu to continue on programming. Or press
VOL UP
then
0
to exit programming mode once you are fi nished.
Talk Time
Talk Time is the period of time allowed for two-way conversations. Fifteen (15) seconds
before the end of the time period the voice prompt will say “Timing out. Press
1
to avoid
disconnection” on the operator end. Enter a number between 30 and 999 seconds. Factory
set default is 180 seconds.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
2
for talk time.
STEP 4 To program a different talk time than the default 180 seconds (3 minutes) press
1
(continued on next page)