Wurtec S3 Communicator Master Station - Programming (Locally or Remotely) - Advanced Options; Access Code

Buy Online! Wurtec.com 15
Programming (Locally or Remotely) | Advanced Options
STEP 5 The phone will say “enter a number between 30 and 999 followed by
#
VOL DN
. The
number you enter is in seconds. For example If you press 45, that would be 45
seconds.
STEP 6 If you have entered the desired talk time correctly you can press
#
VOL DN
to return to the
previous menu to continue with programming, You can repeat the steps again to re-
enter a different number to overwrite the previous one, Or you can press
VOL UP
then
0
to exit programming if you are fi nished.
Access Code
This code enables password protection for programming from a remote location. Enter up to
eight (8) digits. Factory set default is none.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
3
for Access Code.
STEP 4 Press
1
to program an access code. Press
2
to review what the already
programmed access code is (by default there is no access code). Finally you can
press
3
to erase the access code altogether.
STEP 5 Press
#
VOL DN
to return to the previous menu and continue on programming. If you are
fi nished programming you can press
VOL UP
then
0
to exit program mode.