Wurtec S3 Communicator Master Station - Quick Set-Up (Onboard Keypad); Programming Site Identification Message; Adjusting Onboard Volume

Buy Online! Wurtec.com 9
Quick Set-Up (from onboard keypad)
Programming Site Identifi cation Message
STEP 1 Press the
SITE ID
MSG
button on the keypad.
STEP 2 Press
1
to record. The phone will say “at the tone, record your message followed
by
#
VOL DN
. After you heard the tone, record the message and press the
#
VOL DN
key
when fi nished. A typical message consists of the address, name of the building the
elevator is in, and the elevator number if more than one elevator is present, and a
call back number. The site identifi cation message should not exceed 16 seconds.
STEP 3 If the message that has been recorded is correct you may
press
VOL UP
then
0
to exit programming mode. If the message is incorrect and
needs to be recorded again, follow the steps for programming the site identifi cation
message again. The new recording will automatically overwrite the old recording.
You can repeat this process until the message is correct.
Adjusting Onboard Volume
(volume of the programming menu voice)
STEP 1 To increase the volume of the onboard programming menu voice press the
TALK
/ END
and
VOL UP
keys at the exact same time then release. You will hear a “beep”
tone. Continue pressing and releasing
TALK
/ END
and
VOL UP
at the same time until the
desired volume is reached. The “beep” tone will gradually increase. The phone will
say “Invalid Entry” once it has hit its maximum volume.
STEP 2 To decrease the volume of the onboard programming voice press the
TALK
/ END
and
#
VOL DN
keys at the same time and then release. You will hear a “beep” tone.
Continue to press and release the
TALK
/ END
and
#
VOL DN
keys until the desired volume
is reached. The “beep” tone will gradually decrease. The phone will say “Invalid
Entry” one it has reached its lowest volume.