Wurtec S3 Communicator Master Station - Programming S3 C from Master Station; Program from the Master Station

Buy Online! Wurtec.com 7
Programming S3C from Master Station
The Master Station has the capability of programming the S3C phones that are connected to it
remotely. In order to do this the unit numbers must be programmed into the phones fi rst. You
can do this by programming it on the onboard keypad of each phone or programming the unit
number remotely with only one phone connected at a time.
Program from the Master Station
STEP 1 Press the
VOL UP
key on the Master Station Keypad. The phone will say “enter unit
number to speak to that phone or zero to speak to all phones.
STEP 2 Press the number to the corresponding phone you want to program. You are not
allowed to press zero to program all the phones at once.
STEP 3 Once communication has been established you will hear inside the elevator cab
and will have two-way communication. Press
5 5
on the Master Station
keypad. Two-way communication will cease and you will then hear a menu prompt.
STEP 4 Press
2
to program or press
VOL UP
then
0
to disconnect from the phone.
STEP 5 Once in programming mode you can program anything into the phone as if you
were calling in remotely. Use the quick programming guide starting on page 5 to
program the phone, use the full programming instructions starting on page 8, or use
the fl ow chart on page 24.
STEP 6 When you are fi nished programming, press
VOL UP
then
0
to hang up the S3C
elevator phone. Then press
TALK
/ END
to hang up the Master Station. Hanging up
the handset on the Master Station will NOT hang up the phone, it will just put the
Master Station in speakerphone mode.