Wurtec S3 Communicator Master Station - Programming (Locally or Remotely); User Preferences - Announcements On;Off

Buy Online! Wurtec.com 13
Programming (Locally or Remotely)
STEP 3 Press
1
if you want to program the site identifi cation message. Press
2
if you
want to program for in car announcements. Press
#
VOL DN
to return the previous menu.
Or
VOL UP
then
0
to exit program mode.
STEP 4 To program the site identifi cation message press
1
. The phone says “at the
tone, record your message followed by
#
VOL DN
. At the tone, record the message and
then press
#
VOL DN
. If the message is correct you can press
#
VOL DN
to get to the previous
menu and continue programming, if you made a mistake and need to record again,
simply follow the steps again and it will automatically record over the old message.
If you are fi nished programming press
VOL UP
then
0
to exit program mode.
Programming (Locally or Remotely) | Advanced Options
In this group of menus you will have the option to choose user preferences, set talk time,
enter an access code, enter touch tone ID, set ring count and review program status.
User Preferences - Announcements On/Off
Announcements are used to notify persons in the car which of the possible three emergency
phone numbers are being dialed. Use these at your discretion.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
1
for user preferences.
STEP 4 Press
1
for announcements menu.
STEP 5 Once in the announcements menu you can press
1
to turn on the
announcements. Press
2
to review whether or not announcements are on or off.
Press
3
to turn off announcements. Press
#
VOL DN
to return to the previous menu to
continue programming. Or press
VOL UP
then
0
to disconnect.