Wurtec S3 Communicator Master Station - Using the Master Station; Calling Elevator from the Master Station; Calling Outside Line from the Master Station

6 Buy Online! Wurtec.com
Using the Master Station
The Master Station is used to communicate to each S3C phone it’s connected to individually
or all at the same time. The S3C elevator phones still have the ability to call an outside line
by pushing the emergency call button. The S3C phone does NOT have the ability to call the
Master Station. The Master Station can call any elevator phone or it can join a call that has
already been established by the S3C in the elevator.
Calling Elevator from the Master Station
STEP 1 Press
VOL UP
on the Master Station keypad. The phone will say “enter unit number to
speak to that phone or zero to speak to all phones.”
STEP 2 Press the unit number to the corresponding phone you’d like to contact.
STEP 3 Once communication has been established you will have two-way communication
between the Master Station and the S3C in the elevator. Once the conversation
is over press
TALK
/ END
on the Master Station. The S3C elevator phone will hang up
automatically. Hanging up the handset on the Master Station will NOT end the
conversation, it will just put the Master Station into speakerphone mode.
Calling Outside Line from the Master Station
The Master Station can be used as a normal telephone as well as an intercom to the elevator
cars as long as you have a valid telephone line connected.
STEP 1 Press
TALK
/ END
on the keypad of the Master Station. The phone will say “enter number
to be called”.
STEP 2 Using the keypad dial the number you want to call as if using a normal telephone.
STEP 3 After the conversation is over press the
TALK
/ END
key again to hang up the Master
Station. Hanging up the handset will NOT hang up the phone, it will just put the
Master Station into speakerphone mode.