X-Rite Macbeth Lighting SpectraLight QC User Manual

SpectraLight QC
17
Sensor
Monitor
Enabled, Disabled
Disabled
When enabled it displays lamp, input, temp., etc.
sensor data in main menu. Use the up (▲) and
down (▼) arrow switches to view the data.
Switch Name
Generic, Lamp Type
Lamp Type
Allows you the option to display the type of lamp
used (i.e., TL84, CFW, etc.) or display the generic
lamp name (i.e., FL1, FL2, etc.) that appears
above the switches.
EOL
Pre-warning
Off, 80%, 85%, 90%,
95%
Off
Set end of lamp life (EOL) pre-warning
percentage.
Time Format
12H, 24H
24H
Set time format.
Operation
Mode
SPL QC, Control Box
SPL QC
Set the SPLQC or control box mode. Select
“Control Box” mode if you are setting up a control
box.
Password
Disabled, Enabled
Disabled
Enable or disable password protection for the
Administration (ADMIN) Setup.
RF Remote
Disabled, Enabled
Disabled
Enable or disable the use of the optional remote
control.
RF Remote
Addr.
0 to 7
0
Set remote control address code to match the
remote control dipswitch setting. Refer to the
Remote Control Operation section later in this
manual to setup the remote control.
Auto-Off Timer
(min)
0 to 999 minutes
5
Set the amount of time in minutes that the DL, HZ,
and HL lamps change to the FL1 lamp. Set to “0”
if you do not want the lamp change.
Standby Timer
(min)
0 to 999 minutes
30
Set the amount of time in minutes that the unit
goes into standby after the last button was
pressed. Any button pressed on the display panel
will reactivate the unit.
Message
Codes
0 to 255
100
Messages appear on the display as codes; 1-99
for Error and Warning, 100-255 for information.
Message
Repeat
0 to 100
0
Number of times the same message will appear
on the display before it ends.
Key Repeat
Time(ms)
100 to 999
200
Set key automatic repeat interval. Press and hold
the key will produce multi-click events.
2. Use the up (▲) and down (▼) arrow switches to highlight the desired option.
3. After the option is highlighted, press the EDIT switch to access the editing screen.
4. Select desired option or value for the system settings. Refer below for additional information on editing the
system settings.
To select option or value:
• Use the up (▲) and down (▼) arrow switches to highlight the option or select a value.
• Press the OK switch to save the selected option/value.
5. When finished with the system settings, press the EXIT switch to exit the System Settings screen.

X-Rite Macbeth Lighting SpectraLight QC Specifications

General

Brand	X-Rite
Model	Macbeth Lighting SpectraLight QC
Category	Lighting Equipment
Language	English