SpectraLight QC
21
Entering text using the software application:
• Make sure the editing window is displayed and use the Backspace key to delete one character at a time.
• Enter required name (15 characters maximum).
• Press Enter key on the keyboard when finished.
Deleting Profiles
1. To delete a profile, use the up (▲) and down (▼) arrow switches to highlight the profile.
2. Press the DEL switch and then the YES switch to delete the profile.
Editing a Profile
After creating a profile, you can customize the switches and setup an auto sequence.
1. Use the up (▲) and down (▼) arrow switches to highlight the profile that you wish to edit.
2. Press the EDIT switch to access the Edit Profile screen.
3. Enter the required parameters (see below).
4. When finished, press the EXIT switch to exit the Edit Profile screen.
Single Lamp “Tri Lux” Operation (fluorescent tubes only)
The Edit screen is used to edit the high, normal and low lamp lux values. The “Norm” lux value is used for
standard operation. The “Tri Lux” option must be selected for the “Up/Down keys” option in System Setting to
allow the three lux selection during operation.
1. Press the EDIT switch to access the Preset Lux Values screen.
2. Use the up (▲) and down (▼) arrow switches to select High, Norm, or Low.
3. Press the EDIT switch to access the change lamp lux value screen.
4. Use the up (▲) and down (▼) arrow switches to select a value.
5. Press the OK switch when finished.
6. Continue with other lux preset if required.
Enable/Disable Lamp Switches (TOG)
The Toggle function is used to enable or disable switches on the two main menu screens.
To Next Page
Loading...
Need help?
General
