SpectraLight QC
28
Group Screen
This option is used to assign devices (luminaires) to specific groups.
1. To assign a group to devices, press the GROUP switch.
2. Use the up (▲) and down (▼) arrow switches to select a device.
3. Press the EDIT switch and use the up (▲) and down (▼) arrow switches to select a group.
4. Press OK to confirm the assignment.
5. When finished, press the EXIT switch to exit the daisy chain settings screen.
NOTE: The BREAK switch is used to send a “break” signal to the daisy chain. This function is used for servicing.
NOTE: Always switch the power “ON” first to the ‘Slave’ units and the ‘Master’ unit last. Units configured as
‘Slaves’ cannot be addressed independently.
To Next Page
Loading...
