Introduction
1–12 975-0188-01-01
6. Repeat steps 1 through 4 for all banks attached to the BC Series. Each time
yes
is displayed for a newly programmed battery type, the charger exits the
programming mode.
7. At any time during setup, you can press
ON/STANDBY once to cancel the current
change and return to charging or battery monitoring.
To configure the charging type:
1. Press and hold
MODE until
set
(setup) is displayed.
2. Press
MODE to select 2-stage (
2st
) or 3-stage (
3st
) charging. When you have
selected a charging type that is different from the present configuration, the
bank indicator light flashes.
See “About Charging” on page 2–2.
3. Press and hold ON/STANDBY until
yes
is displayed to store the selected mode.
4. At any time during setup, you can press
ON/STANDBY once to cancel the current
change and return to charging or battery monitoring.
BC_Charger_User.book Page 12 Friday, August 12, 2005 3:31 PM
To Next Page
Loading...
