Xantrex GT3.0 - Starting up the GT Inverter; Figure 4-1 AC;DC Disconnect Switch Positions

Starting the Inverter
4–4 975-0131-01-01
Starting up the GT Inverter
To start up the inverter:
1. Switch the AC/DC Disconnect switch to the ON position (see Figure 4-1).
2. Check the GT Inverter LCD. The startup screens (see Table 5-1 on page 5–3)
should appear for five seconds each, and then the “Reconnecting in sss
seconds” special screen (see Table 5-10 on page 5–8) will appear until the
five-minute, five-second (default value) protection timer countdown is
completed.
Figure 4-1 AC/DC Disconnect Switch Positions
AC/DC Disconnect Switch