Installation
2–12 975-0298-01-01
5. Connect the Xanbus cable(s) (and terminator if necessary) to either
network input on the back of the System Control Panel. See Figure 2-9.
Connect a network terminator to the System Control Panel if it is the
last device at the end of a daisy chain network layout.
Figure 2-8
Securing the Mounting Plate
Rotate tabs to
horizontal position
Important:
To ensure communication signal quality, the network must be
terminated at each end with a terminator.
Figure 2-9
Connecting the network cables
To Next Page
Loading...
