-
CODE
-
0
-
1
251
5
only
DESCRIPTION
CODE
DESCRIPTION
CODE
1
2510
only
2
251
5
only
-
3
251 5
only
-
4
251
5
only
DESCRIPTION
Fuser Temperature
Adjustment. In order to
increase the fuser
temperature, press the COPY
CONTRAST
UP
button. In
order to reduce the
temperature, press the COPY
CONTRASTDOWN button.
The value
is
between
1
and
9.
5
Notes
land
2
Exposure Adjustment
The drum
is
charged and the
illumination lamp
is
switched
on.
See ADJ
9.2
Enables an installed foreign
xcessory. The allowable
{alues are:
The foreign accessory
feature
is
enabled. a 450
ms pulse
is
provided near
the end of each
copy.
6
Notes1
and
2
High Voltage Set-up, used to
check and adjust the corotron
voltages. Electrostatic Series
(ADJ
9.2)
The foreign accessory
feature
is
disabled.
Timeout to Power Saver
(USO),
(XLA
60
Hz)
or Low
I'owur (IIX),
(XLA
50
I-lz)
Mode. This
is
the amount of
time from the ready mode to
the power saver
(USO),
(XLA
60
Hz)
or low power (RX),
(XLA
50 Hz) mode and
P
(USO), (XLA
60
Hz) or
L
(RX),
(XLA
SO
Hz)
is
displayed. The
time
is
45
seconds plus
15
multiplied by this value. In
order to increase the time,
press the COPY CONTRAST
UP
button. In order to reduce
the time, press the COPY
CONTRAST DOWN button.
Each increment represents
15
seconds. The value
is
between
1
and
9.
The range
of values
is
from
60
to 180
seconds.
The foreign accessory
locrluro
is
enabled.
a
450
ms pulse
is
provided near
the end of each
incrementing of the copy
count meter.
Re~istrntion,
iisatl
to
ndjirsl,
the registration. Use the
Copy Contrast Up or
Copy
Contrast Down buttons to
change the registration.
ADJ
8.1
Registration
Timeout to Rest (sleep) Mode.
Adjusts the amount of time
that elapes from when the
copier enters the Power Saver
mode (P displayed) until the
copier enters the Rest (Sleep)
mode (rotating segment). To
increase the time, press Copy
Contrast Up. To reduce the
time, press Copy Contrast
Down.
The
timeout
=
NVM
x
15
minutes,
See
ADJ
3.1
Terminates imaging after
1
to
B
feet (0.3 to
2.8
m) of media.
The value entered may be
1
through
9.
A value of
9
allows an unlimited image
length.
Setpoint for the toner
concentration.
See ADJ
9.4
Country Configuration.
1
120
VAC,
60
Hz
2
220
to
230
VAC,
50
Hz
3
240
VAC,
50
Hz
4
100 VAC,
50
or 60
Hz
Mote
I:
During the tests under codes
5
and
6
the fuser
lamp
is
on.
Note
2:
This test will switch on the main
drive motor.
In
order
for
the main drive
motor to run, the fusermust
be
at the
correct temperature.
Lower
Right
Segment
NVM
Reset to Nominal
Diagnostics
To Next Page
Loading...
Need help?
General