To Next Page

To Previous Page

SETTING UP THE FIERY EXP4110 FROM THE CONTROL PANEL

Ethernet Speed

Auto Detect/1 Gbps/100 Mbps Full-Duplex/100 Mbps Half-Duplex/10 Mbps Full-Duplex/

10 Mbps Half-Duplex [Auto Detect]

Select an appropriate setting according to the settings of the network to which the

Fiery EXP4110 is connected. Select Auto Detect if your network environment is mixed or if

you do not know the network speed.

NOTE: If you select Auto Detect, make sure that the auto-negotiation settings for speed and

duplex are conﬁgured for the network port to which the Fiery EXP4110 is connected.

Similarly, if you select a different setting such as 100 Mbps, make sure the same settings are

conﬁgured for the network port.

NOTE: The 1 Gbps (gigabit per second) setting is full-duplex.

Protocol Setup options

To conﬁgure the Fiery EXP4110, choose each protocol and enter the settings for that

protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication simultaneously.

AppleTalk Setup

Enable AppleTalk

Yes/No [Yes]

Select Yes if you have an AppleTalk network connected to the Fiery EXP4110. This setting

enables the Fiery EXP4110 to communicate over AppleTalk networks.

AppleTalk Zone

List of zones

The Fiery EXP4110 searches the network for AppleTalk zones in your network segment.

Scroll through the list to select the AppleTalk zone in which you want the Fiery EXP4110 to

appear. If your segment has only one zone, the Fiery EXP4110 is assigned to that zone

automatically.

The message “No AppleTalk zone found” may mean your network has no zones, or the

network cable is not connected.

TCP/IP Setup options

To conﬁgure the Fiery EXP4110 for TCP/IP, choose TCP/IP Setup.

NOTE: Choose Ethernet Setup and enter the appropriate settings.

Network Setup

Protocol Setup

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110