Xerox 4110 Configuration And Setup

TROUBLESHOOTING
99
Cannot connect to the Fiery EXP4110 with utilities
If users cannot connect to the Fiery EXP4110, check the following:
Fiery EXP4110 Setup: The appropriate network protocol must be enabled, with the correct
parameters (for example, for TCP/IP, the IP address). You must publish either the Print queue
or Hold queue.
You can check these settings quickly by printing a Configuration page.
On the client computer: The appropriate network protocols must be loaded.
Cannot connect to the Fiery EXP4110 with Command WorkStation
If there is a problem connecting to the Fiery EXP4110, an error message is displayed.
The problem can occur when:
• The Fiery EXP4110 is initially turned on
• The Fiery EXP4110 restarts
•You have changed settings affecting the server address and have not reconfigured the
connection to the server
If you experience this problem, try the following solutions, in this order:
•A remote workstation running utilities or WebTools may be interfering by obtaining status
information. If possible, close the remote application, and try to connect again.
•Restart the Command WorkStation software and try to connect again.
•Restart the Fiery EXP4110.

Xerox 4110 Specifications

General

Brand	Xerox
Model	4110
Category	Printer
Language	English