To Next Page

To Previous Page

TROUBLESHOOTING

This chapter provides troubleshooting tips.

Troubleshooting the Fiery EXP4110

Startup diagnostics are described in the documentation for service technicians. Contact your

authorized service/support center if you see startup error messages on Command WorkStation

or if the Fiery EXP4110 does not reach the Idle state.

Runtime error messages

For error messages related to canceling jobs and printing, including the Disk Full message and

alerts to load media, see the Command WorkStation Help.

You can turn on PostScript error reporting as a print option from Mac OS applications.

Check power and cable

This message indicates that the interface cable between the Fiery EXP4110 and the printer is

not connected, or a print job is ready, but the printer is not turned on.

Printer not found

Most failures to ﬁnd a printer on the network are due to conﬂicting or missing name or

address settings for the Fiery EXP4110. You must enter names in speciﬁc places. The required

names are:

•TCP/IP host name (also known as the DNS name), which is deﬁned by your organization.

Enter the host name as the Server Name in Fiery EXP4110 Setup.

•Remote printer (internal machine) name. Use one of the following:

hold

direct

NOTE: If you change the DNS name (also known as the TCP/IP host name) of the

Fiery EXP4110, you must reconﬁgure one of the utilities on each workstation.

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110