SETTING UP THE FIERY EXP4110 FROM THE CONTROL PANEL
57
In the following list of options, default values, where applicable, appear in brackets.
NOTE: For users to access the utilities and WebTools or print to the Fiery EXP4110 over a
TCP/IP network, you must publish at least the Hold queue or the Print queue.
Publish Direct Connection
Yes/No [Yes]
This option allows users to print (or download) jobs to the Fiery EXP4110 without spooling.
Jobs printed to the Direct connection are not saved in the Printed queue.
If you plan to download fonts to the Fiery EXP4110, you must publish the
Direct connection.
Publish Print Queue
Yes/No [Yes]
This option allows users to print (or download) jobs to the Print queue. Jobs that are printed
to the Print queue are spooled to the Fiery EXP4110 hard disk and printed on a first-in, first-
out basis. Only queues published in Printer Setup are available to users.
Publish Hold Queue
Yes/No [Yes]
Use this option to allow users to print (or download) jobs to the Hold queue. Jobs in the Hold
queue can only be printed by copying or moving the jobs to the Print queue with Command
WorkStation.
Save Changes
Yes/No [Yes]
Select Yes to activate any changes made in Printer Setup; select No to return to the main Setup
menu without making any changes.
PostScript and PCL Setup options
These Setup menus allow you to set defaults for the Fiery EXP4110. Users can override most
of these defaults on a job-by-job basis. However, users printing from UNIX or DOS
command lines cannot override defaults from their applications. Therefore, you must set
defaults in Setup. For information about these defaults, see “PS/PCL Setup options” on
page 76.
Exit Setup
Choose Exit Setup from the first screen of the main Setup menu when you have finished
making changes. The Fiery EXP4110 restarts and any changes you saved during the Setup
take effect.
To Next Page
Loading...
Need help?
General